Replacing The Remote Control Batteries - Haverland TE-700I Manual De Instalacion Y Uso

EN 3. OPERATION
3.9. FUNCTIONS CONTROL PANEL
When the towel rail is switched on for the first time, whether the infrared remote control is
switched on or off, THE PILOT LAMP WILL BE ON IN GREEN, indicating that it is Standby.
Pressing button 1 on the towel rail control panel will switch the unit on. THE PILOT LAMP WILL
BE ON IN RED, awaiting commands from the remote control.
Press any remote control button and select any available mode (comfort, economy, etc.).
The pilot lamp will be:
• RED:
1. When the unit is NOT heating. The selected temperature is lower than the ambient
temperature.
2. Moreover, if the tower rail is switched on, but THERE IS NO COMMUNICATION WITH THE
REMOTE CONTROL, for example:
- One of the two black infrared sensors is covered by something,
- The remote control batteries are exhausted and the pilot lamp will be RED.
• FLASHING RED:
1. When the unit us HEATING. The selected temperature is higher than the ambient
temperature.

3.10. REPLACING THE REMOTE CONTROL BATTERIES

The remote control will hold the memory of the bespoke programmes and settings for 1
minute. After this time the information will be erased.
1. Press the tab located on the left side of the device and pull on the front cover in order to
release it. When the two parts are separated, the batteries can be replaced.
2. Replace the three AA LR6 1.5 V batteries with new ones (alkaline batteries are
recommended).
3. In order to close the unit again, fit the front cover to the rear section. Gently press the side
tab so that the two parts correctly fit.
TE700I
34