Listening To The Radio - HoMedics SOUNDSPA PREMIER Manual De Instrucciones E Información De Garantía

Listening to Nature Sounds
1. Select the sound you wish to listen to and press
the corresponding button (Fig 5).
2. To adjust the volume, turn the VOLUME knob
(Fig 1) to your desired level.
3. When finished listening to the sounds you may
turn them off by pressing the POWER button, or
switch to the radio by pressing RADIO (Fig 4).
Note: When the unit is turned on it will
always default to the last mode used.

Listening to the Radio

1. Press the RADIO button (Fig. 4).
2. Use the AM/FM switch located on the back of the unit (Fig. 3) to change
between bands.
3. Rotate the TUNER (Fig. 1) to select a radio station.
4. To adjust the volume turn the VOLUME knob (Fig 1) to your desired level.
5. When finished listening to the radio you may turn it off by pressing the
POWER button. (Fig. 4)
Note: Adjust the antenna on the back of the unit to better the radio
reception if needed.
Using the Auto-Timer
When the power is on and you are listening to a nature sound or the radio
you may set a timer so the unit will automatically turn off.
1. Toggle through the TIMER button (Fig 4) until the corresponding green
LED illuminates next to the time of your choice, 15, 30 or 60 minutes.
2. To cancel the timer, toggle through the TIMER button until the green LED
light is not illuminated, which indicates you are at the off position or press
POWER (Fig. 4).
Figure 5
8
Setting and Using The Alarm
Setting and using Alarm 1 or Alarm 2 (Individually)
1. Slide the alarm switch to ALARM 1 or Alarm 2. (Fig. 3) An ALARM BELL (Fig. 2)
icon will appear on the LCD display.
2. Press the ALARM SET button. (Fig 4.) The time will flash.
3. While the time is flashing press the HOUR button (Fig 1) until you reach the correct
hour. Then press the MIN button (Fig 1) until you reach the desired minute.
4. After 5 seconds the alarm set time will stop flashing and it will be programmed,
or you may press the ALARM SET button to confirm.
Note: The PM indicator also applies to the alarm. You can review the alarm
setting anytime by pressing the ALARM SET button.
5. You may choose one of 3 wake options; BEEP , SOUND, or RADIO by pressing
the ALARM MODE button. A green LED will appear next to the wake mode
selected. (Fig. 4)
NOTE: When using the sound mode, the unit will set to the last sound you
listened to. If you wish to change it press the sound you wish to wake to
(Fig. 5) and then press the POWER button (Fig 4).
6. When the alarm sounds you may:
a. SNOOZE: Press the SNOOZE button (Fig 1). Your sleep time will be
extended by 9 minutes. You may use this feature until you turn the
alarm off.
b. RESET: Turn the alarm off by pressing ANY button on the unit, except
for the SNOOZE button (Fig 4). The alarm clock will automatically
reset for the next day in its current mode. The ALARM BELL icon and
green LED will remain displayed to indicate the alarm is set. If you wish to
change the wake mode follow step 5 under Setting and Using Alarm 1
and Alarm 2 Individually.
c. OFF: To completely turn off the alarm so it is not set for the next day,
slide the alarm switch to OFF.
NOTE: If the alarm sounds for 30 minutes continuously it will automatically
turn off.
9