Attaching/detaching the ASIP
Although optional we STRONGLY advise using the side impact pad (ASIP) where possible to add
extra protection from side collisions.
Locate the side impact pad connector (ASIP) (L) on the child seat nearest to the side of the
8
vehicle (i.e. closest to the door).
9
Press the button on the ASIP and slide it into position
IMPORTANT: Make sure that the ASIP locks into position
To remove: Push the button on the ASIP and remove
Adjusting the child car seat to fit your child
To adjust the height of the child car seat, squeeze the adjustment handle (I) on the back of the
headrest and move the headrest up or down to one of its positions until the correct height is
achieved. The correct height of the headrest is when there is a distance of 1 cm between the
10
shoulder and the lower edge of the headrest. Once the right fit is found, release the handle and
check the headrest to ensure it is locked into position.
IMPORTANT: NEVER place your child in the child car seat whilst it is not fitted in a car. The child car
seat should never be used free-standing as it may tip backwards. Slot the vehicle seat belt' s shoulder
strap through the shoulder belt guide (C) and place the lap belt through the red lap belt (E). Lock the
vehicle seat belt into the buckle ensuring it "CLICKS" into place.
IMPORTANT: The lap belt is worn low over the hips. Check that the lap belt passes through the red lap belt
guides (E) on both sides of the child car seat. Check that the shoulder belt passes through the red shoulder
belt guide (C) then diagonally across the child' s chest and through the red lap belt guide (E) nearest to the seat
belt buckle. Finally, check that all slack has been removed from the seat belt and that your child is now secure.
IMPORTANT: Make sure the seat belt buckle is not wedged or interfering with the lap belt guides (E)
WARNING: An unoccupied child car seat should be secured using a 3-point seat belt or the ISOFIX
connectors if available.
7