- To modify the position of the chisel turn the selector
(C) until points to ( 0 ). Rotate the chisel until the desired
position and turn the selector (C) until points to (
Electronic speed control:
- The speed of the appliance can be regulated by using
the speed regulator control (H). This function is very
useful, as it makes it possible to adapt the speed of the
appliance to the type of work that needs to be done.
- If the appliance works continuously at low speed,
working life of the appliance will be reduced considerably.
Locking button:
- Activating the locking button allows you to operate the
appliance without having to depress the run button
- To activate this function press button (I) while holding
down the run button (H).
- To deactivate this function press the run (H) button
right down.
Once you have finished using the appliance:
- Stop the appliance by releasing the on/off switch (H).
Cleaning
- Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
- Allow it to cool before undertaking any cleaning task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or base
pH such as bleach, or abrasive products, for cleaning
the appliance.
- Do not let water or any other liquid get into the air vents to
avoid damage to the inner parts of the appliance.
- Never submerge the appliance in water or any other
liquid or place it under running water.
- If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration of
the appliance's useful life and could become unsafe to use.
Supplies
- Always use original supplies, designed specifically for
your appliance model.
- These supplies are available in specialist shops.
Anomalies and repair
- Take the appliance to an authorised technical support
service if a product damage or other problems arise.
6
Do not try to dismantle or repair without assistance, as
this may be dangerous.
)
- If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
Specifications:
- Rated power (W):
- Rated Voltage
- No load speed (rpm):
- Blows per minute (ipm)
- Impact Energy (J)
- Maximum capacity in concrete (mm)
- Weight (Kg:)
- Sound Pressure level
- Sound Power level
- Vibration
- Not suitable for use in presence of flammable anaesthetic
mixture with air or with Oxygen or nitrous oxide
NB: These specifications are subject to change without
notice of purpose of improvement.
Wear hearing protection
-Measured sound level determined according EN60745
-The vibration emission level given in this information
sheet has been measured according EN60745 and
may be used to compare one tool with other. It may be
used for a preliminary assessment of exposure
-The vibration value during actual use of the power tool
can differ from the declared total value depending on
the way in which tool is used.
-It's necessary identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to
the trigger time).
For EU product versions and/or in case that it is
requested in your country:
Ecology and recyclability of the product
- The materials of which the packaging of this appliance
consists are included in a collection, classification and
recycling system. Should you wish to dispose of them,
use the appropriate public recycling bins for each type
of material.
- The product does not contain concentrations of
substances that could be considered harmful to the
environment.
CCH26REAK
800
230V~
0-1200
0-5300
2,8
26
2,9
(LpA) = 89.86 dB(A), KpA = 3 dB
(LwA) = 100.86 dB(A), KWA = 3 dB
13.60 m/s2, K= 1.5 m/s2
We he
CASA
compl
60745
61000
Direct
Albert
Comm
Oliana