Cleaning The Electrodes; Troubleshooting; Suction Turbine Turns Off; Suction Capacity Decreases - Flex VCE 35 L AC 110/BS-4h Manual De Instrucciones

Exchanging the flat pleated filter
 Open filter door.
 Take out the flat folded filter.
 Dispose off the used flat-folded filter in
a dust-tight bag according to the statu-
tory provisions.
 Remove the dirt that has accumulated
on the pure air side.
 Insert new flat-folded filter.
 Press the filter foam rim down onto the
edge.
 Close the filter door, it must lock into
place.
Replacing the fleece filter bag
Illustration
 Release and remove the suction head.
 Pull the fleece filter bag towards the
rear.
 Pull the locking slide up and seal the
fleece filter bag tightly when removing
it.
 Dispose of the used fleece filter bag ac-
cording to the local provisions.
 Mount the new fleece filter bag.
 Insert and lock the suction head.
Replacing the disposal bag
Illustration
 Release and remove the suction head.
 Pull the disposal bag up.
 Pull the opening of the disposal bag out
toward the back over the suction sup-
port and seal it tightly.
 Tightly seal the disposal bag with clo-
sure strips underneath the opening.
 Remove the disposal bag.
 Dispose of the used disposal bag ac-
cording to the local provisions.
 Attach the new disposal bag.
 Place the disposal bag over the con-
tainer.
 Insert and lock the suction head.
20

Cleaning the electrodes

 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.

Troubleshooting

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Note: In case of a failure (e.g. filter break-
age) the appliance must be turned off im-
mediately. The failure must be remedied
before the appliance is put into operation
again.
Suction turbine does not run
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, the power plug,
the electrodes and the receptacle of the
device.
 Turn on the appliance.

Suction turbine turns off

 Empty the container.
Suction turbine does not start again
after the container has been emp-
 Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
 Clean the electrodes as well as the
space between the electrodes with a
brush.

Suction capacity decreases

 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Replace the filled fleece filter bag
 Replace the filled disposal bag.
 Ensure the filter cover properly locks
into place.
 Replace the flat pleated filter.
 Test the electrical tool connection.
– 6
EN
tied