Pairing In Rx Mode; Pairing With A Smartphone; Use; Switching On - Marmitek BOOMBOOM 100 Modo De Empleo

4.3.3

Pairing in RX mode

Connect the BoomBoom 100 to your audio system using the
correct connection cable (C, D or E).
Slide the multifunctional switch (2) all the way to the right (BT).
The LED will now start to blink red/blue, indicating that the
BoomBoom 100 is ready for pairing. Now slide the multifunctional
switch back to the centre position for optical connection (OPT), or
all the way to the left for analogue connection (AUX).
4.3.4

Pairing with a smartphone

Turn on Bluetooth on your smartphone and scan for Bluetooth
devices. Select the BoomBoom 100 to pair and connect. Once the
connection has been established, the LED will turn blue or green.
The music from your smartphone is now played through your
audio system.
5

Use

5.1.1

Switching on

The BoomBoom 100 does not start connecting to your devices if
these are already switched on. Therefore, it is advisable to switch
on the BoomBoom 100 first, followed by the previously connected
devices.
5.1.2

Re-pairing

Previously paired Bluetooth devices connect automatically with
the BoomBoom 100 when switched on.
5.1.3

Adjusting the volume

The BoomBoom 100 is a passive transmitter or receiver and does
not have volume settings. The desired volume level must be set
on the devices that are paired with the BoomBoom 100.
5.1.4

Removing paired devices

To remove previously paired devices from memory, please follow
these steps:
Ensure that the BoomBoom 100 is switched on in RX or TX mode.
Slide the multifunctional switch (2) all the way to the right (BT) for
6 seconds.
The LED will first flash red/blue and then turns red/blue constantly.
BoomBoom 100 11