Blaupunkt PG3000 Manual De Instrucciones página 6

LF THE PAINTING MATERIAL
Requires thinning
• To select the correct thinning agent, determine if the material is water based or oil based. For water based paint use
water based thinner. For oil based paints use oil based thinner.
• Start with a 10% dilution of the painting material.
• To do this, fill the Paint Sprayer container with the required amount of paint or material.
• The viscosity cup supplied holds 1/1O of a litre; block the hole in the cup and fill-up with the required thinner.
Add the thinner to the paint and stir. Then measure the viscosity again.
• lf the painting material requires further thinning, dilute by another 5% (5% is equal to half the viscosity cup) with the
correct thinner and measure the viscosity. lf the paint requires further thinning, repeat the process until the correct
viscosity is reached.
TIP - Keep a small amount of paint to one side to add if you over dilute with thinners.
•
FILLING THE PAINT SPRAYER
Ensure the unit is unplugged and switched to the off position.
• Unscrew the container from the spray gun
• After the paint / material has been properly thinned, fill the container to the top of the neck.
• Carefully screw the container back on to the spray gun.
• IMPORTANT - Never fill over the max fill level of 800ml.
ALIGNING THE SUCTION TUBE
• The suction tube inside the container MUST be in place each time you use lhe Paint Sprayer. lf you are going to be
spraying in a downward direction, the angled end of the suction tube should be pointing toward lhe frant of the gun.
• lf you are going to be spraying in an upward direction, the angled end of the suction tube should be pointing toward
the rear of the gun.
NOTE - The Paint Sprayer is not suitable for painting ceilings and/or any surface where lhe Paint Sprayer requires more
•
than a 45 degree angle for spraying.
By pointing the suction tube in the proper direction, you will not have to refill the container asa often
IMPORTANT - Never tip the Sprayer upwards at more than a 45 degree angle.
•
Material could get into the turbine and damage the Sprayer.
•
• NOTE - Ensure the
seal is in place
before screwing
the container back
onto the spray gun.
The seal is located
in the collar of the
Paint Sprayer and
is used to create
an air-tight seal
between the paint
container and the
Paint Sprayer.
S
To
U
Ho
Pr
Sp