Kenmore HE2Plus Serie Manual De Uso Y Cuidado página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Laundry tub drain or standpipe drain
Connect
the inlet hoses to the washer
Connect the drain hose form to the corrugated drain hose.
H. Hot water inlet
C. Cold water inlet
1. Attach the hot water hose to the washer's hot (H) water inlet
valve. Screw on coupling by hand until it is seated on the
washer.
2. Attach the cold water hose to the washer's cold (C) water
faucet. Screw on coupling by hand until it is seated on the
washer.
3. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten.
Damage to the coupling can
result.
4=
Turn on the water faucets completely and check for leaks.
NOTE: Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
Ro :£etse
Hose
Proper routing of the drain hose protects your floor from damage
due to water leakage. Read and follow these instructions.
Remove drain hose from the washer
Gently pull the corrugated
drain hose from the shipping clips.
-X
\
j
A
A. Snap either end of the drain hose form to the drain
hose at the point where the corrugation
begins.
B. Bend drain hose over drain hose form and snap
into place.
To keep drain water from going back into the washer:
Do not straighten the drain hose, and do not force excess
drain hose into standpipe. Hose should be secure, but loose
enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See Floor drain under "Tools and
Parts."
Scue
j/,4 :,se
1. Drape the power cord over the washer top.
2. Move the washer to its final location.
&
Place the drain hose in the laundry tub or standpipe as
shown. See illustrations A and B.
C
4. If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown. See illustration C.
NOTES:
Do not force excess drain hose back into the rear of the
washer.
To avoid siphoning, do not seal the drain hose into the
standpipe.
10

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

He2plus 110.4751 serieHe2plus 110.4753 serieHe2plus 110.4754 serie

Tabla de contenido