Deactivating Preprogrammed Pad
1. Open oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"Pb" or "Pd" indicating "b" or "d" menu.
3. Press desired number pad.
• Display shows heating time, "COOK LEVEL" and
power level if other than 100 percent power.
4. Press MENU b/d pad.
• " dddd " and pad number show in display.
5. Press START pad to save in oven memory.
• To reactivate pad, repeat steps.
6. Press RESET pad or close oven door to exit
programming mode.
Reactivating Preprogrammed Pad
1. Open oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"Pb" or "Pd" indicating "b" or "d" menu.
3. Press desired number pad.
• Display shows heating time, "COOK LEVEL" and
power level if other than 100 percent power.
4. Press MENU b/d pad.
• Display shows "0000" and "READY".
5. Program pad according to "Preprogrammed Number
Pads" section step 5-8.
6. Press START pad to save in oven memory.
• To reactivate pad, repeat steps.
7. Press RESET pad or close oven door to exit
programming mode.
Deactivating Control Panel
1. Open oven door, and close oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press TIME ENTRY pad.
• Display shows "0000" and "READY".
3. Press 1,3,5, and 7 pad in sequence.
4. Press TIME ENTRY pad.
• "LOC" shows in display.
• All pads except TIME ENTRY are disabled.
• To reactivate control repeat steps 1-4.
12