Telcoma Automations WIKI Manual De Instrucciones página 33

GB
FIXING AND ADJUSTMENT OF MECHANICAL STOPS FOR LIMIT SWITCHES
If you want to use mechanical stops, they must be put on their own tracks on the lower
part of the WIKI motor. To adjust the stops, close the gate and slide the mechanical stop 1
until it is next to the motor arm. Fix now the stop using a hexagonal M8x30 screw (wrench
N°13). To use the mechanical stop even in the opening phase, repeat the same operation
on the mechanical stop 2 as described on the drowning below.
MECHANICAL
STOP 2
MECHANICAL
STOP 2
The drawing is referred to the opening and closing phase of the left wing. For the right
one, the position of the two mechanical stops is inverted.
Adjustment of the mechanical stop 1 in closing phase.
Adjustment of the mechanical stop 2 in opening phase.
MECHANICAL
STOP 1
MECHANICAL
STOP 1
33