Cleaning; Blade; Aluminum; Plastic - Robot Coupe MP 350 Turbo Manual De Instrucciones

Once the mixing tool has been attached to the
housing, simply insert the latter into the motor unit,
turning it in an anticlockwise direction.
DETACHING THE MIXING TOOL FROM ITS
HOUSING:
C
To release the mixing tool from its housing, simply
press the button . All that then remains to be
C
done is to remove the housing from the motor unit.
W A R N I N G
• Always unplug the power mixer before
cleaning it!
• Always dilute bleach according to the
instructions on the label
• Never run the motor assembly through a
dish machine.
• The type and concentration of the sanitation
agent must comply with 21 CFR 178 1010
regulations.
• Clean according to local health department
regulations.
10
• THE MOTOR HOUSING
The power mixer must be clean through all stages
of production. Clean between each job using a
detergent or disinfectant. Dilute the detergent /
disinfectant following the instructions normally
specified on it's packaging container. Use a cloth
lightly dampened (not dripping) with the cleaning
Mixing tool
solution.
housing
Do not allow liquid to come into contact with
the electrical components contained within the
Mixing tool
housing. Be careful when cleaning around vents
do not allow liquid to drip or seep into the
housing. Use a cloth lightly dampened (not drip-
ping) with water to remove detergent / disinfectant
then dry using a clean cloth.
After using the power mixer in a hot mixture,
cool the bottom of the tube in cold water before
disassembling the bell from the tube.
Clean immediately after use to prevent product from
sticking to surfaces.

CLEANING

W A R N I N G
Never immerse motor housing and/or handle
in liquid! The housing contains the electrical
components and is not sealed against liquid.
Contact with liquid can cause damage to the
blender and serious injury to the operator.
• THE TUBE AND BELL
There are two ways to proceed:
• Simple cleaning procedure after each different use
- Submerge the tube and bell in water and run for a
few seconds to clean.
- Unplug the power cord.
Complete cleaning procedure on a daily basis
- Unplug the power mixer and rinse the bell under a
water tap.
- Remove the bell from the tube, then remove the
blade (wear cutting gloves) ! Be careful to avoid
damaging the surface of the blade shaft and the
watertight seals.
- Always dilute the detergent/disinfectant (see
above).
- Thoroughly dry all parts before reassembling.

• BLADE

The blade can be removed from the bell for
thorough cleaning.
Always dry thoroughly to avoid spotting.

• ALUMINUM

Use soft-metal-safe cleaning agents!

• PLASTIC

Be careful, many cleaning agents are corrosive and
are not safe for use on plastics!
Do not use strong alkaline detergent (having a high
concentration of soda or ammonia).

• WHISK GEARBOX

Never immerse the whisk gearbox in water. Clean it
with a cloth lightly dampened (not dripping).
Never run the whisk gearbox through a dishwasher.

• WHISKS

The whisks can be cleaned either by hand or in a
dishwasher.
To ensure effective cleaning, always remove the
whisk ejector.