Level The Washer; Complete Installation - Maytag MHN33PDCWW Instrucciones De Instalación

Lavadora comercial de carga frontal
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Level the Washer

Properly leveling your washer avoids excessive noise and vibration.
1. Check the levelness of the washer by placing a level on the top
edge of the washer, first side-to-side, then front to back.
Jam nut
If the washer is against a wall, move the washer out slightly
before tipping back. If the washer is not level, first prop the front
with a wood block and adjust the feet as necessary; then, prop
the back and adjust feet as necessary. Repeat this step until
washer is level.
2. Make sure all four feet are stable and resting on the floor.
Then check that the washer is perfectly level (use a level).
3. After the washer is level, use a 9/16" open-end wrench to
turn the nuts on the feet tightly against the washer cabinet.
Jam nut
IMPORTANT: All four feet must be tightened. If the nuts
are not tight against the washer cabinet, the washer
may vibrate.
4. The washer should not move front to back, side to side,
or diagonally when pushed on its top edges.
5. Slide the washer to its final location.
6. Confirm the levelness of the washer.

Complete Installation

1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements. "
2. Check that all parts are now installed. If there is an extra part, go
back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.
8. To test and to clean your washer, measure 1/2 the detergent
manufacturer's recommended amount of High Efficiency (HE)
detergent for a medium-size load. Pour the detergent into
the detergent dispenser. Select any cycle and allow the washer to
complete one whole cycle.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mhn33prcww

Tabla de contenido