Sun Microsystems Ultra Enterprise 450 Guia página 6

What to Do
To verify that your server supports the 400-MHz CPU modules, you can use a
UNIX
From a Console or from a Command window:
Enter the following command at the UNIX prompt:
% /usr/sbin/prtconf -pv | grep "501-5270"
If the number returned is 501-5270, go to the Section "About UltraSPARC II CPU
Modules" on page 1-3 of this guide.
If no number is returned, the system board is not part number 501-5270. You cannot
install the new UltraSPARC II 400-MHz CPU module into the current main logic
board. Contact your Sun™ sales representative about ordering a board upgrade.
Follow the installation instructions in Ultra Enterprise 450 Server Board Upgrade Guide.
If the ok prompt is displayed:
1. Enter the following command:
ok cd /
2. Enter the following command for the list of data about the system:
ok .prp
Examine the output listed for the model property. If the system board is not part
number 501-5270 (or if there is no part number listing), you cannot install the new
UltraSPARC II 400-MHz CPU module. Contact your Sun sales representative about
ordering a board upgrade. Follow the CPU module installation instructions in the
Ultra Enterprise 450 Server Board Upgrade Guide.
If the number is 501-5270 go to the Section "About UltraSPARC II CPU Modules" on
page 1-3 of this guide.
1-2 Ultra Enterprise 450 CPU Module Guide • December 1998
®
command, or you can find out at the ok prompt.