Assembly J 80 Ultra - Robot Coupe J80 Ultra Manual De Instruccion

ASSEMBLY J 80 Ultra

Feed tube
Grating disc
Ejector
Handles
Sieve
Safety arm
6
1 Motor unit 5 Basket
2 6
Bowl Pulp container
3 Spout 7 Lid
4 Flange 8 Drip tray
1
7
2
5
4
2
3
3
1
8
1) Position the motor
4
unit so that the On/Off
buttons are facing you.
5
2) Place the bowl on
top of the motor unit.
3) Fit the flange onto
the rim of the bowl.
TThe ribs of the flange
should be lined up with
the flat panel of the
bowl. Check that the
flange is correctly
fitted.
You can also refer to the label (below) stuck to the
lid.
4) Lower the basket
into place, holding it
by its handles.
Rotate it until it slots
into place.
5) Line the lid up with
the notches in the
flange
I M P O RTA N T
Make sure that the pin
on the motor shaft is
correctly lined up with
the corresponding
notch in the basket
hub.
7