Technical Specifications; Care And Maintenance - Shad BC01 Manual De Instrucciones

Call functions
When there is an incoming call, the speaker will provide
an acoustic signal.
Answering by pressing the button (1b): press the
control button (1b) only once
Ending a call: press the control button (1b) only once or
wait until the other person hangs up
Rejecting an incoming call: press the control button
(1b) twice, as soon as you hear the acoustic signal for
an incoming call
Redialling: press the control button (1b) twice. This
depends on the features and configuration of your
mobile phone.
Adjusting the volume
The SHAD BC01 device is pre-programmed with a
volume level that allows for optimal listening at speeds
of up to 80 km/h (50 mph). To adjust the volume, use
the volume controls on the connected device.
Volume perception may vary depending on the position
and separation of the speakers from your ears, as
well as the type of helmet and motorcycle, external
conditions and other factors.

Technical Specifications

Bluetooth : 2.1 Class 2
®
Profiles: HSP, HFP, EDR
Battery: Lithium polymer, allowing for up to 7 hours of
talk time and 200 hours of standby time (depending on
use and configuration of the device)
Compatible with SHAD BC03 intercom
Ready to operate as an intercom: you can pair your
SHAD BC01 device to a SHAD BC03 and activate the
intercom mode, without losing the hands-free features
for your phone.
Dual link: While connected to a SHAD BC03, if you
receive a call, the intercom function will stop and then
resume when the call ends.

Care and maintenance

The SHAD BC01 device uses components with
the latest technology and is manufactured to high
standards.
To keep your device from inadvertently becoming
damaged, please read the following recommendations
carefully:
• Do not attempt to open any of the system
components, since the electronic parts inside it may
become damaged. Do not attempt to open or change
the battery as it may be dangerous.
• Keep the SHAD BC01 out of the reach of children.
• Keep the SHAD BC01 in a dry place. Humidity and
condensation may damage the electronic circuits.
• Avoid exposing the device to extreme temperatures.
Intense cold may create condensation inside the
components as these warm up. Extreme heat may
damage the battery, circuits or casings.
• Do not drop, hit or bend the components as the
internal circuits may become damaged.
• Do not paint or decorate the SHAD BC01 as the
casings may become damaged or impede correct
operation.
• Do not use chemical products, solvents or detergents
to clean the SHAD BC01 as these may damage the
device.
Troubleshooting
If you cannot connect your SHAD BC01 device to your
mobile phone:
• Make sure the SHAD BC01 is switched on
• Make sure your mobile phone is switched on and
Bluetooth has been turned on
®
• Make sure both devices are paired
• Make sure the SHAD BC01 device and your mobile
phone are fewer than 10 metres (32 ft.) apart
If, after this, you're still unable to pair or use the SHAD
BC01 with your mobile phone, please contact the
retailer where you purchased the product.
Shortcuts
The SHAD BC01 device allows you to receive calls
automatically (as long as this feature is supported by
your mobile phone). To do this, you need to activate
the automatic response feature in your mobile phone.
Press the control button (1b) to activate the voice
dialling function in the paired phone (the phone must be
configured to allow voice dialling, as long as the phone
supports this feature).
9