Lock Mode - Taylor 9306N Manual De Instrucciones

°F/°C selection
To change the 'ºC' or 'ºF' mode, press the SCAN (infrared) then
the MODE key four times. This will switch between ºF and ºC
selections.

LOCK MODE

The lock mode is useful for continuous monitoring of
temperatures. To use the lock mode, press the Scan key, then
Mode key 3 times, then Scan key again. "Lock" will display
on the screen and the thermometer will continuously display
the temperatures for up to 60 minutes or until the Scan key is
pressed and held. When the Scan key is held and released,
"Hold" will display and the last measurement will remain visible
for 15 seconds and the screen will go blank.
THERMOCOUPLE PROBE FUNCTION
The thermocouple probe is used to measure internal food
temperature quickly and accurately.
To use, open the probe from the housing and insert the probe
into the food to be measured, then press and release the
'PROBE' (green) key to display the temperature. The unit will
continuously display temperatures for up to 4 minutes. After
that, the unit will automatically shut off to preserve battery
life. Pressing the Probe key again will hold the last temperature
and "Hold" will show on the display and the F (or C) will stop
flashing. If there are no further measurements after "Hold"
appears, the unit will automatically shut off after 15 seconds.
NOTE: If Scan is pressed while the Probe function is in use,
the Probe temperature will automatically "Hold" so the Scan
function can be used. If the Probe key is pressed while using
the Infrared function, then the Scan function will "Hold". If
there is no Scan or Probe activity for 15 seconds, the unit will
automatically shut off.
4