Surfaces; Stainless Steel Surfaces (On Some Models); Lights - GE JVX3240 Manual Del Propietario E Instalación

Surfaces

Stainless Steel Surfaces (on some models)

Do not use a steel wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the brush line. Follow
the cleaner instructions for cleaning the stainless steel
surface. Cleaners with oxalic acid such as Bar Keepers
Friend Soft Cleanser™ will
remove surface rust, tarnish, and
small blemishes. To receive a
$2.00 coupon for a trial sample
of Bar Keepers Friend Soft
Cleanser™ follow the link below
or scan the QR Code.
barkeepersfriend.com/ge
Painted Surfaces (on some models)
Do not use a steel wool pads or other abrasive
cleaners; they will scratch the surface.
Clean grease-laden surfaces of the hood frequently. To
clean the hood surface, use a hot, damp cloth with a
mild detergent suitable for painted surfaces. About one
tablespoon of ammonia may be added to the water. Use
a clean, hot, damp cloth to remove soap. Dry with a dry,
clean cloth.

Lights

CAUTION
Let the light bulb cool completely before
removing. A warm or hot bulb may break if touched with
a moist cloth or hand.
Remove the bulb and replace it with a type A15
incandescent light bulb with an ordinary screw base, not
more than 40 Watts.
IMPORTANT: For installation, handling and disposal
precautions, refer to the fluorescent bulb packaging
literature.
To remove the light cover:
are released.
motion.
To replace the light:
that the light switch is turned off.
6
Use only a liquid cleanser free of grit and rub in the
direction of the brush lines with a damp soft sponge.
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer
nearest you, please visit GEApplianceParts.com
NOTE: When cleaning, take care not to come in contact
with filters and other surfaces.
CAUTION
When cleaning the hood surfaces,
be certain that you do not touch the light with moist
hands or cloth. A warm or hot light may break if
touched with a moist surface. Always let the light
cool completely before cleaning around it.
pull out.
incandescent), making sure socket is properly
inserted into the housing of the lamp holder.
To replace the light cover:
the top opening.
the side prongs into the side openings.
Light cover
49-80839-1