Troubleshooting - Whirlpool WFG515S0JW1 Manual De Uso

To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Unscrew the oven light globe then grasp the halogen bulb and
pull out.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty, or visit www.whirlpool.com/product_help. In Canada, visit http://www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
PROBLEM
Nothing will operate
Surface burners will not
operate
Surface burner fl ames are
uneven, yellow and/or noisy
12

TROUBLESHOOTING

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Main or regulator gas shutoff
valve is in the off position.
The range is improperly
connected to the gas supply.
The control knob is not set
correctly.
Air in the gas lines.
Clogged burner ports.
Clogged burner ports.
Burner caps positioned
improperly.
Range converted improperly.
3. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new bulb,
do not touch bulb with bare fi ngers.
4. Replace oven light globe by screwing it back into place
5. Reconnect power.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
SOLUTIONS
Plug into a grounded 3 prong outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See the Installation Instructions.
Contact a trained repair specialist or see Installation
Instructions.
Push in knob before turning to a setting.
If this is the fi rst time the surface burners have been used, turn
on any one of the surface burner knobs to release air from the
gas lines.
See "Sealed Surface Burners" section.
See "Sealed Surface Burners" section.
See "Sealed Surface Burners" section.
If propane gas is being used, contact a service technician or
see cover for contact information.
.