Zyxel PLA491 Manual Del Usuario página 9

2 Press the ENCRYPT button at the rear of your powerline
device for 1-2 seconds. The power (
the powerline device tries to set up a connection.
1...2
• If the power (
pressed the ENCRYPT button for too long. Try again, press-
ing the ENCRYPT button for 1-2 seconds.
3 Repeat step
device you wish to connect. This must be done within 120
seconds of pressing the ENCRYPT button on the PLA491.
4 Check the lights on the two powerline devices. The power
( ) and HomePlug (
Occasionally all lights may blink at the same time and the
HomePlug (
one minute while your powerline devices connect.
• If the HomePlug (
not light up, the powerline devices are not connected.
Repeat steps
ENGLISH
) light does not blink, you have probably
2 in this section for the other powerline
) lights should be blinking.
) light may also show red. Wait for roughly
) lights on both powerline devices do
2 and 3 in this section. If that doesn't work,
) light will blink as
9
1...2