General; Symbols And Abbreviations In These Instructions; Intended Use; Mounting And Installation - Osram DALIeco Control Manual De Instrucciones

DALIeco Control
1

General

1.1 Symbols and abbreviations in these instructions

• Bullet point, listing
1. Numbered steps with stipulated sequence
2.2 Cross-reference to Section (e.g. 2.2) or separate instructions (but then without fi gures)
14 Figure cross-reference (e.g. to Fig. 14)
SP Abbreviation for "Short Press" (<0.5 sec.)
LP Abbreviation for "Long Press" (>0.5 sec)
VLP "Very Long Press" (>10 sec)
DP "Double Press" (each <0.5 sec)
i
Symbol "INFORMATION"

1.2 Intended use

This product has been developed and is intended specifi cally for use with light management sys-
tems for luminaires. Any other use other than that described in these instructions is not intended.
Symbols used in the diagrams
Luminaire is switched on:
"ON"
Automatic switching on of the
lighting by motion detection.
Delay period 1:
After leaving the motion
detection area.
min.
23
Luminaire is switched off:
"OFF"
Manual switching on of the lighting
by external switch.
Delay period 2
min.
2

Mounting and installation

2.1 Dimensions and mounting dimensions

2.2 Connection allocation in the control unit

(1) Mains connection
(2) Mains connection
(3) Spare
(4) DALI 1(-)
(5) DALI 1(+)
(6) DALI 2(-)
(7) DALI 2(+)
(8) Sensor connection (4p4c)
(9) Input external 1. push-button
(10) Sync connection / 2. push-button
(11) GND - Reference potential external push-button

2.3 Plug and Play Function

The DALIeco control unit may be used without additional programming as a purely manual
push-button control system and for fully automatic presence and daylight-dependent control of
individual lights and the lighting of individual rooms.
i Please note:
Several control stations may be provided by parallel connection of the push-buttons
allowing for a maximum total cable length (see technical data).
2.3.1 Manual one-button control
If the control unit is set to factory defaults and while no sensor is connected, it operates as a
single-button control system.
Push-button functions
• SP: Switching DALI CH-1 and CH-2 on and off respectively (toggle function)
• LP: Dimming DALI CH-1 and CH-2 up and down respectively (toggle function)
• DP: Storage of the current light value as an input value

2.3.2 Manual two-button control system

If the control unit is set to factory defaults while no sensor is connected, a two-button control
system may be activated for separate control of DALI CH-1 and DALI CH-2.
Activation of the two-button control system
• Simultaneous VLP for 10s on both push-buttons (lighting indicators flash to verify)
2
3
4a
4b
GB