Operation; Operating Machine - Century FC-90 Manual Del Operador

FC 90

OPERATION

Read and understand this entire section before operating
your CrossLinc Remote.
Safety Precautions
Do not attempt to use this equipment until you have
thoroughly read all operating and maintenance manuals
supplied with your equipment and any related welding
machine it will be used with. They include important safety
precautions, operating and maintenance instructions and
WARNING
parts lists.
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts such as
output terminals or internal wiring.
• Insulate yourself from the work and
ground.
• Always wear dry insulating gloves.
WELDING SPARKS can cause fire
or explosion.
• Keep flammable material away.
• Do not weld upon containers which have
held combustibles.
ARC RAYS can burn.
• Wear eye, ear and body protection.
FUMES AND GASES can
be dangerous.
Although the removal of the particulate
matter from welding smoke may reduce
the ventilation requirement, concentrations
of the clear exhausted fumes and gases may still be
hazardous to health. Avoid breathing concentrations of
these fumes and gases. Use adequate ventilation when
welding. See ANSI Z49.1, "Safety in Welding and Cutting",
published by the American Welding Society.

OPeratinG macHine

Once you have set machine up as per instructions, refer to Table
B.1 and the Procedure Decal located on the inside of the wire
drive compartment door of your machine for setup information,
consumables, and quick tips for welding.
1. Select welding voltage (power), based on the material
thickness of the work piece, required on front panel
2. Select wire feed speed required on 'wire speed' knob
3. Ensure you are wearing the correct safety clothes &
FIGURE 5
equipment for welding (I.E Welding mask, gloves, apron etc)
Gun Cable
4.
Connect the work clamp to the metal to be welded. The work
clamp must make good electrical contact to the work piece.
The work piece must also be grounded as stated in Arc
Welding Safety Precautions in the beginning of this manual.
5.
Based on the weld joint type and orientation of the weld joint,
position the gun into the joint at the correct angle.
6. To begin welding, raise your hand shield or lower your
helmet to protect your eyes and pull the trigger.
7.
While welding, travel at a constant speed and maintain an
electrode stickout of 3/8".
8.
To stop welding, release the gun trigger.
9.
When no more welding is to be done, turn off the machine.
8
OPERATION
Workpiece
Work Clamp