Keypad Beep; Emergency Channel Memory; External Speaker; Pa Function - Midland M Zero Manual Del Usaurio

KEYPAD BEEP

When this function is enabled, you will hear a beep tone everytime a but-
ton is pressed.
To activate/deactivate the beep tone:
1. keep pressed the UP button while turning on the radio;
2. press UP or DOWN to enable/disable the beep;
3. when the beep tone is enabled, the display will show 'ON' and when
it's disabled, 'OF' will be displayed.

EMERGENCY CHANNEL MEMORY

The emergency channel set by default is channel 19; to change it, follow
these steps:
1. move the knob of the CH/EMG selector to EMG position;
2. the current emergency channel blinks on the display;
3. press the UP / DOWN controls for 5 seconds at the same time. The
display will stop blinking;
4. with the UP/DOWN buttons select the new emergency channel;
5. push again UP / DOWN for about 5 seconds;
6. the display will blink again and will indicate the new emergency
channel memory.

EXTERNAL SPEAKER

Connect a speaker with a power of 3-10 Watt to the EXT jack.
When you connect an external speaker to the radio, the internal speaker
is automatically disconnected.

PA FUNCTION

The PA function allows you to use the radio as an audio amplifier.
1. Connect a speaker with a power of 3-10 Watt to the PA jack;
2. move the CB/PA knob in PA position;
3. press the PTT button of the microphone and talk.
M Zero Instruction Guide | 11