Echo SRM-225 Instrucciones Para La Instalacion Del Conjunto página 2

2
i
nstallation
Tools Required: 8mm x 10mm Open End Wrench, T-wrench,
Torx T-27 L-Wrench
1. Close choke and remove air filter and cover.
2. Disconnect ignition stop leads (A) and (B).
3. Loosen nut (C) and remove throttle linkage from carburetor
bracket (D).
4. Remove inner throttle cable (E) from carburetor swivel (F).
5. Loosen the two (2) drive shaft clamp bolts (G) at engine drive
shaft clamp.
6. Pull drive shaft assembly from clutch case.
7. Loosen two (2) rear handle screws (H) and pull rear handle from
the drive shaft assembly.
8. Loosen four (4) screws (I) and remove front handle.
9. Insert square nut (J) in lower handle bracket (K) and place bracket
on drive shaft 400mm (15 3/4 in.) from engine end of drive shaft.
10. Secure with lower handle bracket clamp (L) and three (3) 5 x 25
mm bolts.
U-H K
andle it
i i
nstallation nstrUctions
C
A
B
E F
D
G
I
H
J
K
L
H