Cadet RM162 Guía Para El Propietario página 4

INSTALLATION INSTRUCTIONS
__________________________
How do I install for new construction?
Route Supply Wires
STEP 2
Route supply wire from circuit breaker to thermostat to wall can.
Remove a knockout and attach the supply wire with a strain relief
connector leaving 10 inches wire lead for later use. Connect sup-
ply ground wire to grounding pigtail in wall can (See Figure 5).
Proceed to PART TWO.
__________________________
If you are installing a Multi-Watt heater, model numbers RM151, RM162, or RM168, begin with STEP 1 below. If you are installing an
RM202, RM208, RM158, or RM108, begin with STEP 2 below.
Element Wire Configuration (Multi-watt models RM151, RM162 and RM168 only)
STEP 1
Cadet's Multi-Watt RM heater offers a variety of heat output options. You must first determine the desired wattage and then configure
the heating element wire connections. The heater is shipped from the factory configured for maximum watts: 1600 Watts (240V) and
(208V) for RM162 and RM168, and 1500 Watts (120V) for RM151. If this is the wattage you desire, proceed to STEP 2.
On models RM151, RM162 and RM168, mark wiring diagram on the back of the heater with the wattage used for future reference.
IF YOUR DESIRED
MODEL VOLTAGE WATTAGE IS:
RM162 240V
RM168 208V
RM151 120V
*Cut Blue Terminal from Red Wire and wrap up with electrical tape. Yellow
Y
Terminal remains connected at
Page 2 for terminal locations.
Figure 8a RM Wiring Table
Install Heater Assembly
STEP 2
Set the heater assembly (blower wheel first) into the left side of the wall can. Fasten at top with screw provided. Unlace heater lead
wires. Connect the supply wires to the heater wires (See Figure 9). Keep all wires away from element connections when wires are
pushed into free space on right of heater.
Install Grill
STEP 3
Secure grill with the screws provided. If you have a built-in thermostat model, slide thermostat knob onto shaft. Turn power on at the
electrical panel board.
Page 4
YOUR WIRES WILL BE CONFIGURED LIKE THIS:
Upper Element
900W-240V
1600 Yellow Terminal
900 Yellow Terminal
700 None (*)
900W-208V
1600 Yellow Terminal
900 Yellow Terminal
700 None (*)
1000W-120V
1500 Yellow Terminal
1000 Yellow Terminal
500 None (*)
B
. Do Not Touch. Refer to Wiring Diagram on
__________________________
Part One
How do I install in an existing wall?
Mount Wall Can
STEP 3
Insert wall can, legs first, into opening and rotate into wall. Keep-
ing front of wall can flush with finished surface, secure to wall stud
with screws through larger (3/16 inch) holes. (See Figures 6 and
7).
IMPORTANT: Insert two drywall screws into the small holes
opposite the wall stud into the drywall to rest against backside of
sheetrock (keeping wall can flush to wall).
Proceed to PART TWO.
Figure 6
__________________________
Part Two
A C
Lower Element
700W-240V
X Z
Blue Terminal
X
None (*)
X
Yellow Terminal
700W-208V
X Z
Blue Terminal
X
None (*)
X
Yellow Terminal
500W-120V
X Z
Blue Terminal
X
None (*)
X
Yellow Terminal
Figure 9
(continued)
Figure 7
Figure 8b