Special Cuts; Cutting Bowed Material; Cutting Round Or Irregularly Shaped Material - Bosch GCM18V-12GDC Instrucciones De Funcionamiento Y Seguridad

1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 59

Special Cuts

with operation. Before switching on, lower
head assembly to make sure clamp clears
guard and head assembly.
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep
hands at least six (6) inches (152mm)
away from the projected path of the saw
blade.
spacing from hand to saw blade, extend
the sliding fence and base extensions
when making extreme bevel, miter or com-
pound cuts.

CUTTING BOWED MATERIAL

8
CUTTING ROUND OR IRREGULARLY
SHAPED MATERIAL
Saw Operations
Use clamping position
that does not interfere
Be aware of the path of
the saw blade. Make a
To provide sufficient
(minimum 6" [152mm])
30
30
8
Bowed
Material
30
8
Round
Material
Fig. 62
No Gap at
This Point
Fig. 63
59