Publicidad
3. Press F4 to access the IPS recorder menu. Choose menu option 1 or 2 to continue, or
option 3 to cancel and return to IPS. F4 can also be used to return to IPS from any point
within IPS recorder.
Menu Option 1: Select / Create Program
Select this menu option to choose an existing program in memory or to create a new pro-
gram into which the G-code will be inserted.
1. To create a new program, input the letter 'O' followed by the desired program number
and press the WRITE key. The new program is created, selected, and displayed. Press the
WRITE key once more to insert the IPS G-code into the new program.
2. To select an existing program, enter an existing program number using the O format
(Onnnnn), then press the WRITE key to select and open the program. To choose from a
list of existing programs, press the WRITE key without input. Use the cursor arrow keys to
choose a program and press WRITE to open it.
MANUAL
SETUP
CENTER DRILL
0
CENTER DEPTH
0.0000 in
CENTER PECK
0.0000 in
WRK ZERO OFST
54
X CENTER PT
0.0000 in
Y CENTER PT
0.0000 in
BOLT CIRCLE
BOLT LINE
3. Using the arrow keys, move the cursor to the desired insertion point for the new code.
Press WRITE to insert the code.
96-0041 Rev T
January 2009
IPS Recorder Menu
FACE
DRILL
POCKET MILLING
Select / Create Program
DRILL TOOL
TAP TOOL
0
0
O00000 (PROGRAM A)
O00001 (PROGRAM B)
DRILL DEPTH
TAP DEPTH
O00002 (PROGRAM C)
0.0000 in
0.0000 in
O00003 (PROGRAM D)
O00004 (PROGRAM E)
O00005 (PROGRAM F)
DRILL PECK
O00006 (PROGRAM G)
*
0.0000 in
R PLANE
NUM OF HOLES
0.2000 in
0
Choose a program by using the cursor
keys and press WRITE to select.
CENTER HOLE
DIAMETER
or
Enter a 'O' followed by a new program
0.0000 in
number and press WRITE to create.
ANGLE
0.000 deg
SINGLE HOLE
MULTIPLE HOLES
ENGRAVING
VQC
F4 CANCEL
0
Press <CYCLE START>
to run in MDI or <F4>
to record output to a
program.
0
11
Publicidad
