Federal Signal SSTX3-MV Instrucciones De Instalación página 3

INSTALLATION INSTRUCTIONS FOR MODEL SSTX3-MV
Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death to you or others.
People's lives depend on your safe installation of our products. It is important to
follow all instructions shipped with the products. This device is to be installed by a
trained electrician who is thoroughly familiar with the National Electric Code and will
follow the NEC guidelines as well as local codes.
The selection of the mounting location for the device, its controls and routing of
the wiring is to be accomplished under the direction of the Facilities Engineer and
the Safety Engineer. In addition, listed below are some other important safety
instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this
equipment.
• This unit must be installed by a qualified electrician in accordance with all
National and local Electrical Codes, under the direction of the authority having
jurisdiction.
• Do not connect this unit to the system when power is on.
• All effective warning speakers produce loud sounds, which may cause, in
certain situations, permanent hearing loss. You should take appropriate
precautions such as wearing hearing protection.
• After installation, test the sound system to ensure proper operation.
• All effective warning speakers produce loud sounds, which may cause, in
certain situations, permanent hearing loss. The device should be installed
far enough away from potential listeners to limit their exposure while still
maintaining its effectiveness. The OSHA Code of Federal Regulations 1910.95
Noise Standard provides guidelines, which may be used regarding permissible
noise exposure levels.
• Show these instructions to your Safety Engineer and then file them in a safe
place and refer to them when maintaining and/or reinstalling the unit.
• Consult the Authority Having Jurisdiction in your area regarding the proper use
and installation of this product.
I. GENERAL.
The Model SSTX3-MV is a solid-state signaling device designed for general purpose
signaling in hazardous locations. Any one of three distinct signaling tones may be selected
by remote dry contacts. This model is suitable for use in areas with high ambient noise levels
and can be installed either indoors or outdoors. An adjustable mounting bracket is provided to
allow positioning for desired sound coverage.
EXPLOSION-PROOF ELECTRONIC SIREN
SAFETY MESSAGE TO INSTALLERS
-1-