Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1. Make sure the power is o . Remove the lamp (If applicable) from the socket.
2. Thread the socket pigtail (M) into the recessed can socket (Figure 1).
3. Take o the mounting bracket (F) and the washer (I) from the inner/outer sections for channel brace (C/D) by removing the two
1/4" long side screws (H) (Figure 2).
4. Raise the adjustable channel brace (C/D) into the recessed can and slide the inner and outer sections of the channel brace as
wide as possible, so that the both ends of the brace are against the sides of the recessed can, move the locking bar (E) to the
center of the channel brace, then tighten the center screw (G) (Figure 3).
5. Secure the sliding bar to the recessed can, by using the two supplied 1" long self piercing screws (N). By using a power drill and a
1/4" hexagon driver, drive the two screws through both sides of the channel brace to the side of the recessed can (Figure 4).
Note: Do not use any other type of screw. These screws are speci cally designed for this application. Only two screws are
needed, two extra screws were provided for your convenience.
6. Install the mounting bracket (F) and the washer (I) back onto the channel brace (C/D), by using the two side screws (H) removed
from step 3 (Figure 5).
Note: The washer must be used for 5" & 6" can installations; Do not use the washer for 4" can installation.
7. Install the green ground wire with screw (K) to the side of the recessed can using ground screw (J) (Figure 6).
8. Raise the metal cover plate (A), rotate it and make sure the mounting bracket holds the metal cover plate in place (Figure 7).
9. Install your lighting xture's mounting bar (Q) (Not included, it comes with the lighting xture purchased separately) on mount
ing bracket (F) with two 1/2" long xture screws (O) (included) (Figure 8). Follow the installation instructions included with your
luminaire to mount onto the recess can converter kit.
10. Insert the lighting xture wires through the decorative medallion center hole (B), and place the decorative medallion onto the
canopy (Figure 9). Note: Decorative medallion is held in place by installed xture.
11. Make the electrical connection between the pigtail (M) and your xture's electrical wires, and raise the decorative medallion and
xture canopy. Secure the canopy according to your lighting xture installation instruction (Figure 10).
M
C&D
F
H
O
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF
are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting
All rights reserved.
Made in Vietnam
F
C&D
H
J
K
B
Recessed Light Converter
I
E
A
2
Instruction
G
N
Publicidad
