Warnings For Installers; Video Door Phone Installation; Description Of Terminals - Urmet mini note + 1722 Serie Manual De Instrucciones

6.

WARNINGS FOR INSTALLERS

Read the notes in this manual carefully. This manual contains important information on safe installation, use and maintenance.
• This devices in the kit must only be put to the use for which they were intended. All other use is improper. The manufacturer cannot be held
responsible for damage deriving from improper, incorrect or unreasonable use.
• Each part was designed to be compliant with the standards in force.
• The system must be built in compliance with the regulations in force. All devices in the system must be exclusively used for the purpose for
which they were designed.
• Remove the components from the packaging and check that they are intact.
• Keep the packaging (plastic bags, polystyrene, etc.) away from children. Packaging is potentially dangerous.
• Provide a suitable cut-off and protection master switch upstream from the devices, with contacts open by at least 3 mm.
• Make sure that the plate data corresponds to the power specifi cations before connecting the devices to the mains.
• Keep the ventilation or cooling openings and slots free.
• Disconnect the devices from the mains before cleaning or maintenance.
• Do not use spray products to clean the device.
• Disconnect power from the circuit breaker in the event of failure and/or malfunctioning of the products contained in the kit. Do not tamper
with the devices.
• Exclusively contact a service centre authorised by the manufacturer for repairs.
• Provide suitable ventilation.
• Do not use power extension wires.
• Have the device checked and repaired by qualifi ed personnel in the case of infi ltration of fl uid or objects inside the device.
• Exclusively use the spare parts supplied by the manufacturer for repairs.
• Installers must make sure that user's information is applied to the connected devices.
• Disrespect of these precautions can effect safety of the devices.
• Keep this manual with the device at all times.
• The lightening symbol in a equilateral triangle indicates the presence of dangerous voltage.
• Never open the devices unless expressly instructed to do so in this instruction manual.
• The exclamation mark symbol in an equilateral triangle indicates critical safety components. Always only use components supplied by the
manufacturer.

7. VIDEO DOOR PHONE INSTALLATION

Install fl ush-mounting box at the height indicated in the drawing below.
Fix the bracket to the mounting box or to the wall as indicated.
Program the dip switches.
Box Mod. 503
n° 2 M3,5 x 19 mm
included
B3
(*) In order to guarantee compliance with reference standards for use by disabled users (e.g. Law 2005-102 of 11/02/2005, Decree 2006-
555 of 17/05/2006 and amendments of 01/08/2006, 26/02/2007 and 21/03/2007 for France), the video door phone screen must be
positioned at the height in the range from 0.90 and 1.30 m (2.95 ÷ 4.27 ft).
7.1.

DESCRIPTION OF TERMINALS

]
LINE IN Bus Line input
]
LINE OUT Bus Line output
}
Z
Output for connecting supplementary ringers (OP2)
K
}
X2
Button
X1
}
Y2
Button
Y1
20
Box Ø 60 mm / 2.36''
n° 2 2,9 x 13 mm
countersunk screws
n° 2 screws and screw
anchors included
B4 / B5
DS1722-098A