Oreck DualMax Guia Del Usuario página 11

Wire Assembly
Recessed
channel
Truman Cell
5. Place each in sink, bathtub or other location where cleaner
can cover every surface.
6. Spray Oreck Assail-a-Cell
and cover each surface. Allow the cleaner to soak for a few
minutes but do not let it dry. Thoroughly rinse the Truman
Cell with clean water.
®
An alternative method to clean the Truman Cell
or soak it in warm water for loose debris. Mild liquid dish
detergent in water may also be used to help break down
tough dirt and residue. Thoroughly rinse the Truman Cell
with clean water.
Note: To prevent damage to the components of the Truman
Cell , do not put in dishwasher or use a cotton swab.
®
Tough residue such as tar from tobacco smoke may need
additional cleaning or longer soaking.
Shake excess water from the Truman Cell
7.
drying time. Do not use heated or compressed air to dry.
8. Reassemble the Wire Assembly and Truman Cell
inserting the (4) post located on the outside edges of the
Wire Assembly into the recessed channels of the Truman
Cell . After guiding the post into the recessed channels,
®
slide the Wire Assembly until it locks into place.
9. Place the Truman Cell
in and turning each knob to its locking position. The Truman
Cell is specially designed so that it can only be inserted in
®
one direction.
10. Close the Cover securely.
10
cleaner between each Cell Plate
®
back into the unit by sliding it straight
®
Post
is to rinse
®
®
to speed up
®
by
®