Cargo Rack (X2 Se) - Segway 24078-00001 Manual De Instalación

Cargo Rack (for x2 SE model)
24042-00001 (Cargo Rack)
Tools required
• 4 mm hex wrench
• Torque wrench
Installation
1. Make sure the PT is powered off and unplugged.
2. Install six Rubber Grommets to each Cargo Rack as shown in Figure 8.
3. Install one Quick Release Knob to each Cargo Rack using two 16 mm
fasteners and two Nyloc nuts, as shown in Figure 9. Torque the fasteners
to 6.0 N-m (4.4 ft-lbf).
4. Position the Cargo Rack so it aligns with the Side Cargo Frame as shown
in Figure 10.
5. Thread eight of the included 35 mm fasteners through the Cargo Rack
into the Side Cargo Frame. Torque the fasteners to 6.0 N-m (4.4 ft-lbf).
Removal
1. Make sure the PT is powered off and unplugged.
2. Remove the Cargo Rack in the reverse order of the above procedure.
NOTE
Refer to the Weight Limits and Maximum Allowable Cargo Weight
sections (p. 3) before using this accessory.
Parts
(4) 16 mm hex fastener
(2) Cargo Rack
(16) 35 mm hex fastener (4) Nyloc nut
(12) Rubber Grommet
(2) Quick Release Knob
7
IMPORTANT
Be sure to read and understand all
warnings (p. 3) at the beginning of
this Installation Manual.
Figure 8. Install Rubber Grommets
Figure 9. Install Quick Release Knob
Figure 10. Install Cargo Rack