Measuring Resistance; Measuring Temperature - General Toolsmart TS04 Manual Del Usuario

MEASURING RESISTANCE

To avoid electrical shock or damage to the meter when measuring resistance,
turn off all power to the circuit and discharge all high-voltage capacitors.
(1) Turn the rotary switch to the
, k or M appears on the right side of the LCD.
(2) Plug the black test lead into the front-panel COM jack and the red test lead
TEMP
into the
mAµAVΩ
(3) Measure the resistance by touching the test leads to the desired test points
of the circuit or to the terminals of a component, as shown below.
RED TEST LEAD
(4) Read the measured resistance on the display. If you are working in Manual
Ranging mode and the readout is .OL, the resistance value is beyond the
currently selected range. If that is the case, use the FUNC button to select
the next-widest position.

MEASURING TEMPERATURE

The DMM includes a "K" type bead thermocouple probe for measuring surface
temperatures. To use it,
(1) Insert the +V plug of the plug adapter to which the thermocouple is
attached into the
(2) Insert the COM plug of the plug adapter into the COM jack of the DMM.
(3) Turn the rotary switch to the TEMP position.
(4) Press the FUNC button until your preferred temperature measurement
unit—ºF or ºC—appears on the right side of the LCD.
(5) Attach the bead probe to the surface whose temperature you wish to
measure. The reading will be shown on the LCD.
••
Ω
jack.
TEMP jack.
mAµAVΩ
••
Warning
position and press the FUNC button until
BLACK TEST LEAD
11