Safety Instructions - General Toolsmart TS04 Manual Del Usuario

1. Indicates DC voltage or current measurement
2. Indicates AC voltage or current measurement
3. Negative polarity indicator
4. Bluetooth enabled indicator
5. Indicates Auto power off
function is enabled
6. Low battery indicator
7. Indicates detection of non-
contact voltage
8. Autoranging mode indicator
9. Indicates LCD is showing maximum session value
10. Indicates LCD is showing minimum session value
11. Indicates data is being held
12. Diode check mode indicator
13. Continuity check mode indicator
14. Measurement units
15. Measured value

SAFETY INSTRUCTIONS

To avoid possible electric shock or personal injury, and to avoid damaging the
meter or the equipment under test:
• Before using the meter, inspect the case. Do not use the meter if it is
damaged. Look for cracks or missing plastic. Pay particular attention to the
insulation around the connectors.
• •WARNING Inspect the test leads for damaged insulation or exposed metal.
Check the test leads for continuity. Replace damaged test leads before using
the meter.
• Verify the meter's operation by measuring a known voltage. Do not use the
meter if it operates abnormally. Protection may be impaired. When in doubt,
have the meter serviced.
••
Warning
Fig. 2. All possible
display indications
••
5