Pairing This System With A Bluetooth Device - Sony SHAKE-X30 Manual De Instrucciones

Pairing this system
with a BLUETOOTH
device
Pairing is an operation where
BLUETOOTH devices register with
each other beforehand. Once a
pairing operation is performed, it
does not need to be performed
again.
If your device is an NFC-compatible
smartphone, the manual pairing
procedure is not necessary. (See
"One Touch BLUETOOTH Connection
by NFC" (page 28).)
1
Place the BLUETOOTH device
within 1 meter (3.3 feet) from
the unit.
2
Press BLUETOOTH on the unit to
select the BLUETOOTH function.
"BLUETOOTH" appears on the
display.
Hint
When there is no pairing information
• •
on the system (for example, when
you use the BLUETOOTH function
for the first time after purchase),
"PAIRING" flashes on the display and
the system enters the pairing mode.
Proceed to step 4.
If the system is connected to
• •
a BLUETOOTH device, press
BLUETOOTH on the unit to
disconnect the BLUETOOTH device.
3
Hold down
unit for 2 seconds or more.
"PAIRING" flashes on the display.
26
US
PAIRING on the
4
Perform the pairing procedure
on the BLUETOOTH device.
For details, refer to the operating
instructions of your BLUETOOTH
device.
5
Select the system's name (for
example, "SHAKE-X30") on the
display of the BLUETOOTH
device.
Perform this step within 5 minutes,
otherwise pairing will be canceled.
In this case, repeat from step 3.
Note
If passkey is required on the
BLUETOOTH device, enter "0000".
"Passkey" may be called "Passcode",
"PIN code", "PIN number", or
"Password".
6
Establish connection with the
BLUETOOTH device.
When pairing is completed and the
BLUETOOTH connection is
established, BLUETOOTH device
name appears on the display.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
You can check the BLUETOOTH
device address by pressing DISPLAY
repeatedly.
Note
You can pair up to 9 BLUETOOTH
• •
devices. If the 10th BLUETOOTH device
is paired, the oldest paired device will
be deleted.
If you want to pair with another
• •
BLUETOOTH device, repeat steps 1 to 6.
To cancel the pairing operation
Hold down PAIRING on the
unit for 2 seconds or more until
"BLUETOOTH" appears on the
display.