Hella JUMBO 320 FF Instrucciones De Montaje página 13

EN
MOUNTING
A min. B min.
(mm) (mm)
350 1.500
13
When mounting auxiliary lamps
with integrated position light it is ne-
cessary to observe certain mounting
dimensions. If these statutory moun-
ting regulations are not observed,
or if the use of an additional pair of
position lamps is not permissible do
not operate the position lights.
Leave the lamp socket in the auxiliary
lamp to prevent leakage.
Installation must take place in
accordance with ECE R48.
It is however essential that coun-
try-specific laws are observed.
C min. D min.
(mm) (mm)
400 600
For upright/pendant mounting, above/
below bumper. Lamps should neither
vibrate nor extend higher than the
bonnet and must be fitted symme-
trically.
Determine mounting position on flat
surface and mark mounting points.
Drill pilot hole with 3 mm dia. bit and
then bore out to 11 mm.
Protect drilled metal parts with rust
protection paint.
Preliminarily install mount.
Open housing and install bulb.
Do not touch bulbs with bare fingers!
Use tissue paper or similar.
Assemble housing.
Screw holder and housing together
and route cable cleanly.
Screw lamps to vehicle (use two-point
mount if required).
Align lamps and tighten screws.