Reservoir; Outside Surfaces - Nautilus Dol-Fyn AR18 Guía De Uso Y Cuidado

CAUTION: To prevent personal injury or property damage, only unplug boiling
chamber power cord after POWER and FAN switches are turned OFF, distiller is
unplugged from the wall outlet and the unit has com pletely cooled.
3) Remove the rubber gasket from the boiling chamber. Clean the gasket with a
mild detergent, rinse and dry thoroughly.
4) Dispose of the water and residue from the boiling chamber and wipe
with a cloth and clean water. To avoid risk of electrical shock, do not
immerse the boiling chamber in water or any other liquid for cleaning.
5) Clean the boiling chamber by combining two cups of white vinegar and
enough warm water to fill the boiling chamber. Allow this solu tion to sit in
the boiling chamber for at least six hours, or preferably overnight. Commercial
descalers or kettle cleaners may be used in place of the vinegar following the
manufacturer's instructions.
6) Dispose of the cleaning solution and rinse the boiling chamber thoroughly
with clean water. DO NOT IMMERSE. If stubborn scale deposits remain they
may be removed with a nylon scouring pad. Then wipe the boiling chamber
thoroughly with a cloth and clean water. Do not tap on the heater to remove
deposits. Tapping on the heater may damage it.
7) Replace the gasket on the boiling chamber and reassemble to the distiller
unit (see page 12), tightening the lid with the lid cover knob. Plug the boiling
chamber power cord into the receptacle and then plug the distiller back into
the wall outlet. Your distiller is now ready to continue providing you with
fresh distilled water.

RESERVOIR

It is recommended that you steam clean your distiller and reservoir once every 6
months (see page 6 for instructions). If your distiller has a demand pump, turn the
POWER OFF and unplug the pump.

OUTSIDE SURFACES

Your distiller has been designed to require minimal maintenance. The exterior
of the distiller and reservoir tank may be wiped with a soft cloth or sponge
dampened with warm soapy water. A commercial glass or stainless steel cleaner
may be used to maintain the luster of the exterior. Do not use abrasive or solvent
based cleaners. DO NOT SPRAY CLEANING PRODUCTS DIRECTLY INTO THE
DISTILLER OR RESERVOIR.
The distiller's cooling system vents (see page 5) should be vacuumed occasionally
or cleaned with a soft brush to remove dust and debris. The distiller must be shut
OFF and UNPLUGGED during this procedure.
Do not attempt to clean the condensing coil, contact your authorized
distributor for assistance.
16