Health Zenith SL-5412 Guia De Inicio Rapido

Motion Sensor Light
Control
As an ENERGY STAR
Zenith has determined that this product
meets the ENERGY STAR
energy efficiency. This product is ENERGY
®
STAR compliant when used with 120 Watt bulbs.
Model SL-5412
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
This package includes:
Rubber Plug
Lamp Holders
Cover
Plate
Sensor
Light Control
Mounting Strap
Mounting Bolt
Plastic
Hanger
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
© 2002 DESA International
Mode:
Test
Auto
Manual
® ® Note: When first turned on wait about 1
Partner, Heath /
®
guidelines for
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.
Put the ON-TIME switch in the 1, 5 or
10 minute position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
2 Shells
then back on to toggle between AUTO
and MANUAL MODE.
Gasket
Manual mode works only with the ON-
TIME switch in the 1, 5, or 10 position.
6 Screws
(3 sizes included)
2 Wire
Connectors
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
OPERATION
On-Time:
5 Sec
1, 5, 10 min.
Until Dawn*
* resets to Auto Mode at dawn.
the circuitry to calibrate.
TEST
AUTO
MANUAL MODE
Mode Switching Summary
TEST
Move ON-TIME Switch to
AUTO
MANUAL MODE
Works: Day Night
x x
x
x
1 / minutes for
2
ON-TIME
10 5 1 TEST
ON-TIME
10 5 1 TEST
1 Second OFF
then...
... back on.
1, 5 or 10 minutes
Flip light switch off
for one second then
back on*
595-5545-06