(All the example assembly images are a Type 4 configuration with motor to the right).
Step 40. (Type 3, 4, 5 and 6)
Introduce the fixing connectors of the arm supports in the box profile groove
just assembled through the only side that is open. Use as many units as arms
are in the configuration (for a Type 4, two units; Type 5,
depending on where the odd arm is placed, two or three
units; Type 6, three units.) as shown in Step 36.
Step 41. (Type 3, 4, 5 and 6)
Connect and assemble the Ø85 axis for one or two motors.
a. Ø85 axis connection.
b. Introduce half of the joint in one of the Ø85 axis.
All dimensions in mm, unless otherwise stated.
c. Fix the joint of the Ø85 axis with twelve DIN 7504-N 3.5x9.5 self-drilling screws
placed in the grooves so that the heads stick out as less as possible from the
exterior of the tube.
d. Attach the joint to the second Ø85 axis.
e. Fix the joint to the second Ø85 axis with twelve
DIN 7504-N 3.5x9.5 self-drilling screws placed in
the grooves so that the heads stick out as less as
possible from the exterior of the tube.
KÝMA
57