Mounting The Housing; Mounting Procedure - Bosch UHI-SBG-0 Manual De Instalación

UHI-SBG-0 Series
6

Mounting the Housing

The UHI-SBG-0 housing includes a J-mount which features a removable camera bracket and
locking grooves to keep the housing from drooping. The mount is vertically adjustable by
pushing the housing up or down.

Mounting Procedure

1.
2.
.
Fig. 6.1 Feeding the Wire using the Bottom NPT Fittings
Fig. 6.2 Feeding the Wire using the Rear NPT Fittings
3.
Fig. 6.3 Mounting the J-mount and Housing
4.
5.
Bosch Security Systems, Inc.
Determine a proper location for the housing.
Insert the coax and power lead wires from the wall through the supplied J-mount allow-
ing enough slack to pull through the housing (see Figure 6.1 on page 13 if using the bot-
tom glands or see Figure 6.2 on page 13 if using the rear glands).
Prepare the surface for mounting and install the J-mount.
Place the UHI-SBG-0 housing on top of the J-mount while feeding the wires through the
bottom or rear NPT fittings.
Make sure that the weight of the camera is distributed evenly.
Installation Manual
Mounting the Housing | en
September 15, 2006 | F01U032279_01
13