Super Ego SEGO TIMER Instrucciones De Configuración página 8

GB
Instructions for configuration
must be programmed from step 1 in
paragraph Programming.
Delayed watering (when watering
must start at a given time)
Water for the first time at 5.00 in the
morning (programming at 22:00 hours).
Then, repeat watering two times a day
for 20 minutes:
1. VERY IMPORTANT: To program any
watering mode, always start with
the RUN TIME rotary knob in ON and
then set the FREQUENCY rotary knob
to RESET.
2. The red lamp blinks. (If the red lamp
does not blink, turn the FREQUENCY
rotary knob to any position and set it
back to RESET).
3. Set the RUN TIME rotary knob to
position 20 to select the watering
duration.
4. Press the YELLOW button 7 times (as
the time difference between 22:00
hours and 05:00 in the morning is
7 hours). Every time the YELLOW
button is pressed, the blinking red
lamp triggers a GREEN light flash.
ATTENTION: If step 4 is not made
while the red lamp blinks, the timer
will not memorise the previous steps.
Therefore, the watering sequence must
be programmed from step 1.
5. After the 7 hours delay setting and
with the red lamp blinking, set the
FREQUENCY rotary knob to position
12.
6. Listen to a "CLICK" sound meaning
the timer valve has opened and the
GREEN light flashes to confirm the
selection made.
NOTES
- Watering modes must be programmed
with the red lamp blinking. Otherwise,
the timer will not memorise the
previous steps.
- To interrupt watering at any time, turn
the right knob (RUN TIME) to OFF.
- For watering manually, just turn the
right knob (RUN TIME) to ON.
The purpose of the YELLOW button
is to delay watering. Every time the
YELLOW button is pressed with the Red
Led blinking, a GREEN light flashes. This
GREEN light flash means watering has
been delayed one hour. Watering can
be delayed a maximum of 12 hours.
This option allows programming the
watering at a given time.
8