Contimac BOXER CM 210 10 3W Manual De Instrucciones página 3

Congratulations! You just bought the best compressor on the market.
Read the following booklet carefully and follow its instructions before you start using the machine in order to avail
yourself of its potentialities without endangering your safety or damaging the appliance.
This CE mark indicates that the compressor meets with CEE Directives 89/392, 89/336, 87/404, EN 292/2, EN 294, EN
60204-1.
Safety precautions Strictly observe the following safety measures:
1. Do not carry out any electric or mechanic operation. If problems arise, immediately call the supplyer.
2. Do not spray at flames or heat sources.
3. Please avoid, above all in very hot climates or during summer, a prolonged exposure of the machine to the
direct rays of the sun, in order not to overheat plastic parts.
Starting the machine. Make sure no damages due to carelessness or negligence occurred during transportation, before
you start the machine. If this should be the case, notify the dealer or transportation company immediately. After having
checked the equipment observe the following instructions:
a. Remove the electric cable and insert the plug in a current collector of adequate power. Make sure if fits tightly
and it ensures the connection of the poles of the plug to the grounding. Make sure the mesh voltage
corresponds to the value indicated on the table of the fairing.
b. To help the electric motor start, make sure the air hose in not under pressure and the air outlet cock (ref. 2 fig.
A) is open.
c. Start the electric motor by operating on the switch (ref. 1 fig. A) and by leaving the air outlet cock (ref. 2 fig. A)
open.
Use. The compressor is equipped with an air flow adjuster (ref. 3 fig. A) which enables the operator to control the
working pressure. Said pressure is measured with a manometer (ref. 4 fig. A).
Connect the chosen accessory to the air outlet cock (ref. 2 fig. A) and, keeping it closed, operate on the knob of the
regulator (ref. 3 fig. A) until the desired working pressure is reached. After this operation is completed, open the cock
until the needed air capacity is reached. Keep in mind that, by alternately adjusting both the regulator and the cock, an
optimal pressure air ratio can be obtained.
Turning the machine off. The compressor is equipped with an air pressure switch (ref. 5 fig. A) which automatically
control the starting and turning off procedures of the compressor electric motor; nevertheless, to stop the compressor
independently from the air pressure switch, use the general red switch (ref. 1 fig. A).
IMPORTANT: Never stop the motor by unplugging the unit! This should be done when the compressor already switch
off.
Maintenance. Unscrewing the filter (ref. 6 fig. A) clean it periodically by an air jet moving from the center to the
outside. Because of the compressor and rapid expansion of the air inside the tank, the humidity in the air condensates.
It is therefore necessary to periodically discharge the condensate from the tank by unscrewing the drain plug (ref. 1 fig.
A) and slightly tilting the tank.
Important. The electric motor is protected by a thermic circuit breaker: said protection device is activated when the
motor overheats and causes sudden stop or intermittent workings.
In this case, make sure that:
a. The network voltage corresponds to the one indicate on the label.
b. The maximum calibration pressure of the pressure switch is less than or equal indicate on the label.
c. No strange noise or vibration is notes when the compressor is functioning.
Warranty. The compressor s guaranteed for a period of 24 months from purchase date for construction faults. It is
important to keep to original purchase document to vouch for the validity of the warranty. It is furthermore necessary
to use the compressor as indicated in this booklet and to show it has not been tampered with. The warranty covers only
the replacement of those parts which are faulty because of assembly or manufacturing defects. All transportation or
operation fees are charged to the clients.
ENGLISH