Setting The Am Tuning Step; Switching The Auxiliary Setting; Switching The Dimmer Setting; Adjusting Display Contrast - Pioneer SUPER TUNER III D FH-P4200MP Manual Del Operador

Initial Settings

Setting the AM tuning step

The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
 1,602 kHz allowable) to 10 kHz (530  1,640
kHz allowable).
1 Press FUNCTION to select AM.
Press FUNCTION repeatedly until AM appears
in the display.
2 Press c or d to select the AM tuning
step.
Pressing c or d will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX ap-
pears in the display.
2 Press a or b to turn AUX on or off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g.,
AUX :ON).

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1 Press FUNCTION to select Dim.
Press FUNCTION repeatedly until Dim ap-
pears in the display.
2 Press a or b to turn Dim on or off.
Pressing a or b will turn Dim on or off and
that status will be displayed (e.g., Dim :ON).

Adjusting display contrast

Display contrast adjustment lets you adjust
the display for easier viewing when lighting
conditions change.
1 Press FUNCTION to select CONT.
Press FUNCTION repeatedly until CONT ap-
pears in the display.
2 Press c or d to adjust the contrast.
Each press of c or d increases or decreases
the contrast.
14  1 is displayed as the contrast is increased
or decreased.
Switching the RCA output
setting
This units RCA output can be used for sub-
woofer. You can select whether to use the sub-
woofer control (low pass filter) built-in
P/O:Subw or the auxiliary P/O:Full.
1 Press FUNCTION to select P/O.
Press FUNCTION repeatedly until P/O appears
in the display.
2 Press c or d to switch RCA output set-
ting.
Pressing c or d will switch between
P/O:Subw (subwoofer) and P/O:Full (non fad-
ing) and that status will be displayed.
Section
11
43
En