Install Infant Car Seat - Quinny ZAPP Guia Del Usuario

To Use
WARNING
To avoid serious injury:
• Use ONLY Mico TM infant car seat (not included)
with this stroller (model 01474).
• Please refer to the manufacturer's instructions
for the use of your infant car seat.
• ALWAYS install car seat facing to the rear of
the stroller.
• ALWAYS use the restraint system in the car
seat.
10

Install Infant Car Seat

Remove the seat. Push the parking brake pedal down.
Insert left and right car seat adapters into hinge points
until you hear a "click" (Figure 10).
Car seat must be in rear-facing position.
Lower car seat into car seat adapters until both sides
"click" (Figure 10a).
To remove car seat, press both buttons on car seat
(Figure 10b). Lift car seat up.
To remove car seat adapters, press gray button and
slide adapter off hinge points (Figure 10c).
10
10a
10c
6
10b
TM