Signal Flow - VOX Amplification StompLab I B Manual De Usuario

far either has veered.
When in tune, both the Tuner center LED will light up.
Adjusting the tuner calibration
You can adjust the reference pitch of the internal tuner (piano
center frequency A). You can calibrate this reference pitch in a
range of 438Hz–445Hz.
When you turn off the power, the calibration adjustment that you
made will be discarded and the StompLab will automatically
be set to 440Hz.
1. Change the reference pitch with the  or  button when the
tuner is starting up.
The program/value display will indicate a reference pitch
(38-45: 438-445Hz).
Creating your sound (Edit mode)
The Edit mode is where you can set the effects that are used in each
category, such as [PDL] (PEDAL), [AMP/DR] (AMP/DRIVE), [CAB]
(CABINET), [NR] (NOISE REDUCTION), [MOD] (MODULATION),
[DLY] (DELAY) and [REV] (REVERB).

Signal flow

PEDAL AMP/DRIVE (Lo/Hi - Mid)
REVERB DELAY MODULATION
CABINET
NOISE REDUCTION
Entering Edit mode
1. In Program select mode, press the EDIT button. You will enter
the Edit mode and the EDIT LED will light up.
Selecting effects and adjusting the parameters - [PDL],
[AMP/DR], [CAB], [NR], [MOD], [DLY], [REV]
Select an effect to use in each category and set the parameter.
1. Select the category with the CATEGORY selector.
2. Select the effect with the  or  button.
The program/value display will indicate an abbreviation of the
effect name and the Tuner
For the effects and parameters that you can select, please refer
to the "Appendices" section on page 50.
When you select an effect, the StompLab automatically sets the
parameters of that effect to the most effective values.
By adjusting the parameters, you can tweak your sound to
what you have in mind.
To turn an effect on/off, press both the  and  buttons
simultaneously. When an effect is on, the effect name is
shown, and when an effect is off, the display indicates "oF".
3. Set the effect parameter with the VALUE 1 knob and VALUE
2 knob.
As you turn a knob, the program/value display will indicate
the values. For VALUE 1 the Tuner center LED will light up
and for VALUE 2 the Tuner
For the effect parameters that are assigned to each knob, please
refer to the "Appendices" section on page 50.

LED will light up.
#
LED will light up.
9