Switching Off The Machine - Kruger KX130 Instrucciones Para El Uso

4
HIGH PRESSURE PIPE CONNECTION
- Insert the high pressure pipe (Fig. 5-pos.3) into
appliance attachment (4)
- Rotate the plastic ring nut, thoroughly tightening it
- Turn on the water tap
Assembly of the detergent spraying device
(Fig. 6)
- Insert the nozzle into the spray gun
- Rotate the nozzle by 90°, and on extracting it,
click it in.
5
ELECTRICAL CONNECTION OF THE
APPLIANCE
The mains voltage must match the operating voltage.
(See identification plate)
- Insert the plug into a power socket installed in
compliance with regulations.
Check the minimum section of the individual cables
using extensions.
Position the extensions so as to maintain the protection
class of the equipment.
Voltage Cable
V length m
230 up to 2
230 20 to 5
6
APPLIANCE ACTIVATION
Operate the equipment in vertical position
only after connecting the water supply pipe
and turning on the tap (fig.2)
- Press button I (Fig.7-ON) on the
main switch positioned at the rear of the device
- Position the spray gun on the object to be
cleaned - never on people !
- Press the safety device (Fig. 8 - pos. 1) - the gun is
released
- Direct the nozzle downwards (Fig.2)
- Fully press down the trigger (Fig. 8 - pos.2)
7

SWITCHING OFF THE MACHINE

- Press the button marked with an 0 on the switch
(Fig. 7 - OFF)
- Turn off water supply tap.
- Actuate spray gun until water drips from the nozzle
(machine is now de-pressurized).
- Release trigger.
- Press safety latch on spray gun. (Fig.9). The spray
- Unplug machine from socket outlet.
- Disconnect water supply hose from machine and
Variable nozzle
The nozzle (6 - Fig.1) can be adjusted continuously by
turning the black bushing: from a pinhole jet (Fig.10)
to flat jet (Fig.11). Furthermore, you can also change
the pressure from low pressure to high pressure by
turning the grey collar (Fig. 12-13).
Turbo nozzle (5 - Fig.1 - optional)
The turbo nozzle, is ideal for maximizing cleaning,
cannot be adjusted.
ADDITION OF DETERGENT
Cross-section
This product is equipped with dual detergent tanks.
2
mm
The detergent selector
1,5
the suction between detergent tanks
2,5
increase/decrease detergent flow.
Fill the detergent tank (Fig. 15) with detergent, di-lute
as recommended. (see paragraph "General safety
recommendations" in this booklet).
HOSE REEL KIT - (optional) (13-Fig.1)
Insert the high pressure hose threaded nut coupler
into the relative slot in the drum, until the central pin is
exceeded. (Fig.16)
Bend and pull the hose checking that the nut correctly
fits inside the drum. (Fig.17)
Wind the same in the direction indicated in Fig. 18.
14
gun is locked and cannot be actuated accidental-
ly.
water supply mains.
8
ACCESSORIES
The detergents must not be al-
lowed to dry on the object to be
cleaned.
(3-Fig. 14)
CAUTION: before undertaking
any operations on the machine and
relative accessories disconnect the
plug from the power socket.
is used to control
(1-2-Fig. 14) and