Walk-Testing - Paradox Magellan MG-PMD85 Guia De Instalacion

Depending on the sensitivity setting, an
alarm condition can be generated between
0.25 sec. (highest) and 2 sec. (lowest) after
the actual movement.
Viewing Sensitivity Settings
Remove the cover to view how many times
the LED flashes, then adjust the setting
accordingly. The LED flashes a consecutive
amount of times to show the setting. Thus if
the sensitivity is set to 6, the LED flashes 6
times. If no action is performed after three
minutes, the LED will exit sensitivity display
mode and return to its normal operation.

Walk-testing

At 20°C (68°F), open and close the cover to put
the detector into Walk-Test mode. The Walk-Test
mode will stay active for three minutes.
At the highest sensitivity setting and in Single
Edge Processing mode, you should not be able
to cross more than one complete zone
(consisting of 2 beams, left and right sensor
detecting elements) in the coverage area with
any kind of movement; slow/fast walking or
running.
At the lowest sensitivity setting, the amount of
movement required to generate an alarm is
doubled. The approximate width of a full beam at
Reference & Installation Manual
http://www.bakonline.net/
5n