Replacing The Battery In The Remote Control; Stop Mode; Additional Functions - APRILIA Meta System Instrucciones De Uso

!

REPLACING THE BATTERY IN THE REMOTE CONTROL

When the battery is flat, please do not throw it away with your normal household waste; dispose of it in the
special recycling bins.
To replace the battery, unscrew the screw on the back and separate the two shells. Take the flat battery out
and put a new one in: make sure you insert the battery the right way up (see illustration).
You should replace the battery with a new CR 2032 3V Lithium battery (item code 222120050).
STOP MODE is used to reduce the chance of flattening your motorcycle battery.
This function enters operation when:
- It has been more than 10 days since the alarm system was last armed using the remote control, or armed
automatically, without any alarm being triggered;
- The motorcycle's battery is becoming flat.
The alarm system "wakes up" out of STOP MODE when the ignition key is turned to the ON position. In this
case, the alarm system returns to its previous status when it was last armed.
As soon as the ignition key is turned to the ON position, the buzzer will emit a series of acute sounds, lasting
for 5", and will then start an alarm cycle. Press the remote control to disarm the alarm system.
The system is able to monitor the status of the vehicle's battery and the alarm system's own internal battery
used for its back up power supply (rechargeable but not replaceable) and will notify you with an acoustic
warning signal.
Vehicle battery: battery maintenance is necessary if you hear 4 short warning signals after disarming the
alarm system.
Internal battery (back up power supply): the internal battery needs charging up if you hear 4 short warning
signals after arming the alarm system.
Use the vehicle to charge it up.
- Do not leave remote controls where they can be damaged by high heat, water or impact.
- After the product has been fitted, we recommend testing all of its functions on a regular basis by following
the instructions in the CHECKING OPERATING STATUS section.
Contact a service centre in case of any malfunction or for any further information.
This product is only a means of discouraging potential theft. It should not be considered any sort of insurance
against theft. The manufacturer is not liable for any fault or operating failure of the product, of any of its
accessories or of the vehicle's wiring system caused by improper use.
The manufacturer reserves the right to make any changes considered necessary at any time without notice.
CAUTION
"RISK OF EXPLOSION IF THE BATTERY IS
REPLACED WITH THE INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO
INSTRUCTIONS BELOW"
BATTERY
POSITIVE

STOP MODE

ADDITIONAL FUNCTIONS

RECOMMENDATIONS
WARNING
pag. 13