Technical Service - Powermate PFTT142.1 Manual De Operación

Maintenance
• Save all instructions
E
How to Prepare for Storage
WARNING
Never store the tiller indoors with fuel in the fuel tank .
Never store in an enclosed, poorly ventilated area where
fumes could reach an open flame, a spark or a pilot light as
on a furnace, water heater or clothes dryer . Allow engine to
cool before storing unit .
WARNING
Do not remove gasoline while inside a building, near a fire,
or while you smoke . Gasoline fumes can cause an explo-
sion or a fire.
NOTE: A yearly checkup or tune-up at an authorized service
center will make sure that the tiller will provide maximum
performance for the next season .
When the tiller is put in storage for thirty days or more, the
following steps should be followed to make sure the tiller is in
good condition the next season . To prevent fuel gum deposits
and corrosion in the unit's carburetor and fuel system, it is
highly recommended to use a fuel additive/stabilizer formulated
for ethanol fuels. Follow the stabilizer manufacturer's
instructions . Run the engine for at least 5 minutes after adding
stabilizer .
1 . Let the engine run until it is out of gasoline . Remove
carburetor screw from bowl and drain fuel . Tilt unit
slightly to remove all fuel . Replace screw . (Figure 19)
2 . Change the oil by following instructions under "How to
Change the Oil ."
3 . Remove the spark plug from the cylinder . Pour one
ounce (1 oz liq . US / 30 ml) of oil into the cylinder .
Slowly pull the recoil-start handle so that the oil will
protect the cylinder . Install a new spark plug in the
cylinder . Pull starter handle slowly a few times to

Technical Service

You may have further questions about assembling, operating, or maintaining this TILLER . If so, you can contact our
Technical Service Department at 1-800-737-2112 (English only) .
You may also write to:
METL Corporate Office - CORRESPONDENCE ONLY
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Date Code on Product
• Your Phone Number
Questions? Call Toll Free at 1-800-737-2112
(Continued)
distribute oil . Pull recoil handle slowly until resistance is
felt . This will close the cylinder valves .
WARNING
DO NOT attach spark plug wire to spark plug when
storing unit .
4 . Clean tiller . Remove all dirt, leaves, debris, grease, etc .
from the tiller - including cylinder cooling fans, recoil
starter cover holes, under fuel tank, and under muffler.
5 . Check the tiller for worn or damaged parts . Have
damaged parts replaced if necessary .
6 . Tighten any loose hardware .
7 . Apply lubrication as directed in Maintenance section .
8 . Put the unit in a building that has good ventilation .
9 . Cover the tiller with a breathing material .
bowl and drain fuel . Replace screw .
If you need assistance or have any questions, CALL
TOLL FREE: 1-800-737-2112.
ENG - 18
Copyright © 2018 MAT Engine Technologies, LLC
Remove carburetor screw from
Figure 19