The Administration Tab - Management; Figure 5-40: Administration Tab - Management - Linksys WRT150N Guia Del Usuario

Wireless-N Home Router

The Administration Tab - Management

When you click the Administration tab, you will see the Management screen. This screen allows you to change
the Router's access settings and configure the UPnP (Universal Plug and Play) features. You can also back up and
restore the Router's configuration file.
Management
Router Access
To ensure the Router's security, you will be asked for your password when you access the Router's Web-based
Utility. The default password is admin.
Router Password.
Router Password and Re-enter to Confirm. It is recommended that you change the default password to one of
your choice. Enter a new Router password and then enter it again in the Re-enter to Confirm field.

Figure 5-40: Administration Tab - Management

Web Access
Web Utility Access. HTTP (HyperText Transport Protocol) is the communications protocol used to connect to
servers on the World Wide Web. HTTPS uses SSL (Secured Socket Layer) to encrypt data transmitted for higher
security. Select HTTP or HTTPS.
Web Utility Access via Wireless. If you are using the Router in a public domain where you are giving wireless
access to your guests, you can disable wireless access to the Router's Web-based Utility. You will only be able to
access the Utility via a wired connection if you disable the setting. Select Enabled to allow wireless access to the
Utility, or select Disabled to block wireless access to the Utility.
Remote Access
Remote Management. To permit remote access of the Router, from outside the local network, select Enabled.
Otherwise, keep the default setting, Disabled.
Web Utility Access. HTTP (HyperText Transport Protocol) is the communications protocol used to connect to
servers on the World Wide Web. HTTPS uses SSL (Secured Socket Layer) to encrypt data transmitted for higher
security. Select HTTP or HTTPS.
Remote Upgrade. If you want to be able to upgrade the Router remotely, from outside the local network, select
Enabled. (You must have the Remote Management feature enabled as well.) Otherwise, keep the default setting,
Disabled.
Chapter 5: Configuring the Wireless-N Home Router 40
The Administration Tab - Management