Symmons SCOT SLC-6000 Serie Manual De Funcionamiento Y Mantenimiento página 5

Installation with MAXLINE
SCOT FAUCET
(SLC-6000)
DO NOT
REMOVE TAPE
TEMPERED
WATER LINE
TO HOT
WATER SUPPLY
MAXLINE THERMOSTATIC
MIXING VALVE
(7-210-ASB)
Important: DO NOT REMOVE tape on copper tubing.
Thermostatic Mixing Valve
™
FIGURE 1
SLC-6000-ML
COLD
WATER LINE
TO COLD
WATER SUPPLY
VALVE
OUTLET
COLD WATER
BYPASS TEE
FITTING
For applications using MAXLINE thermostatic mixing
valve.
1) Turn off water supplies.
2) Connect tempered water line of faucet to thermostatic
mixing valve outlet (see Figure 1 for piping reference).
Note: Valve and cold water bypass use compression
fittings (fittings not supplied).
3) Connect cold water line of faucet to the cold water
bypass using supplied tee fitting.
4) Connect copper tubing from cold water bypass tee fitting
to thermostatic mixing valve.
5) Connect hot water supply to thermostatic mixing valve
and cold water supply to cold water bypass tee fitting.
6) Remove aerator from faucet. Turn handle to full cold
position. Open supply, holding down handle for 10 sec-
onds. Rotate handle to full hot position, open supply and
repeat above procedure. Hold down handle and rotate
from left to right to flush lines to prevent foreign matter
i.e. copper chips, sand, stones, etc. from clogging and
possibly damaging the sealing surfaces of the faucet
cartridge.
5